Solid 316 Stainless Steel Tactile Stud Floorsafe

 All of our quality 316 Stainless Steel Tactiles are factory polished & come with a 10-year warranty.

Technical Data 

• Code: T01 
• Type: Warning tactile 
• Material: Solid 316 Stainless Steel 
• Dimensions: Outer Diameter 35mm x Height 4.5mm 
• Flat glue down tactile 
• Slip Rating: P5 (test report available on request)

Features

• Produced by CNC machine with milling finish 
• The tactile head will not separate from its anchor 
• 10 Year warranty 
• Corrosion Proof

Compliance Floorsafe Australia’s T01 Stainless Steel Tactiles comply with the following standards

•  National Construction Code 
• Section D3.8  Australian/New Zealand Standard 1428.1 2009 – Design for access and mobility – Design for access and mobility: General requirements for access – New building works 
• Australian/New Zealand Standard 1428.4.1 2009 – Design for access and mobility – Means to assist the orientation of people with vision impairment: Tactile ground surface indicators
• Australian/New Zealand Standard 4586 – 2013 – Slip resistance classification of new pedestrian surface materials

Installation Instructions

Make sure you remove any debris & dust and make sure the surface is completely dry.

A light sandpapering applied to the back of the Tactile will also assist adhesion.

1. Use masking tape to mark the area where the tactiles have to be installed.

2. Place the template into position and tape corners to hold the template firm.

3. Remove the plastic cover plug from the top of the Tactile adhesive cartridge. Fit the long stem plastic mixing nozzle onto the end of the cartridge as printed on the cartridge instructions.

4. Place a small amount (Tic Tac size ) of the adhesive into the centre of each circle.

5. Place the Tactile into position and turn the stud a half a turn to allow the glue to spread under.

NOTE: Too much adhesive will spread outside of the Tactile and show.

6. Once the template is complete with the tactiles very carefully lift and remove it.

7. To continue place the first 3 circle rows on the template over the last 3 rows of completed tactiles. This will make sure the line is running straight. Continue as item 4.

8. Upon completion remove the mixing nozzle and replace the cap back onto the top of the cartridge for further use at a later stage.

Luminance Contrast
The Building Code of Australian/New Zealand and the AS/NZS 1428.4.1 require a minimum luminance contrast of 30%. Guidelines are as follows

• Integrated tactile indicators – not less than 30% across the entire area
• Discrete (individual) tactile indicators – not less than 45%
• Where Discrete tactile indicators are constructed of two colours or materials the raised section shall have a minimum contrast of 60%

Test – AS.NZS 1428.4.1 2009 Appendix E (pg 70-77)